Updates and Shipping times will be listed on the bottom of the front page of our website!
Due to pending federal legislation all 80% sales are final. No refunds once milled.
6-Pack TAC-980 80% 9mm Receiver with Drilling Jig
Polymer 9mm Glock Compatible 80% with Metal Inserts in Key Areas
All Pictures are from Production Prototypes
Using the proven design of our TAC-9 we are changing gears and offering the same design but in the home builders option of an 80% receiver. These receivers finish exactly like our AR-15 style 80% receivers
The TAC-980 80% 9mm Receiver is compatible with Glock-style magazines in 9mm/40S&W builds. The ambidextrous magazine releases will be included in the purchase and all other parts are from any quality AR15 lower parts kit. Any AR15 style upper will fit but as there is no mil-spec standard for the design some fit better than others. The most important thing to remember is to use a Glock-cut Bolt and at minimum a 7oz buffer. As all 9mm AR uppers are gas blowback you will need a heavier than normal buffer. The Glock-cut bolt refers to the ejector height being a bit higher to accommodate the magazine design. The way to check is to look on the underside of the bolt at the two grooves toward the chamber end. A Glock compatible bolt will have one of the grooves much deeper on the left hand side of the bolt.
TAC-980 w/jig comes with a one time use jig and trigger hole guide. All you need is a drill press and the following bits to complete your 80% project which can be purchased here Drill Bits & End Mill Kit
5/16" End Mill
5/16" Drill Bit
3/8" Drill Bit
5/32" Drill Bit
All TAC-980's will be shipped to the address in the "Shipping Address" portion of the checkout process . If you have special shipment needs , please list them in the "Comments" section of the checkout process.
Return and Exchange policy: We will only accept returns and exchanges on unaltered 80% blanks. Any manufacturing defects or exchanges will be processed on a case by case basis.